...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
Tekstowy podgląd strony 5 (kliknij aby zobaczyć)
Power Amplifier APPLICATIONS � Px600.2
The JBL Px600.2 amplifier can be set up for stereo or bridged-mono operation, as shown in Figures 4 and 5. NOTE: For simplicity, Figures 4 and 5 do not show power, remote and input connections.
PX600.2
Figure 4. The JBL Px600.2 amplifier is set to stereo mode to drive a pair of full-range speakers.
GND
REM
BATT
BRIDGED STEREO R L
NEON
NEON
Px600.2
POWER
FUSES
SPEAKER OUTPUTS
Px600.2
Set MODE to FLAT; INPUT MODE to ST
(on input panel) X-OVER
FREQ
(rear panel)
32Hz 320Hz FLAT HP LP MODE ST INPUT MODE MO
12dB 24dB SLOPE
R Speaker
L Speaker
FREQ and SLOPE have no effect
Figure 5. The JBL Px600.2 amplifier is set to bridged (mono) mode to drive a single subwoofer. Use this mode only when the nominal impedance of the subwoofer is 4 ohms or greater.
NEON
GND
REM
BATT
BRIDGED STEREO R L
NEON
Px600.2
POWER
FUSES
SPEAKER OUTPUTS
Px600.2
Set MODE to LP; INPUT MODE to MO
(on input panel) X-OVER
FREQ
(rear panel)
32Hz 320Hz FLAT HP LP MODE ST INPUT MODE MO
12dB 24dB SLOPE
Subwoofer (4 ohms or greater)
See �Setting the Crossover(s)� on page 6 to set FREQ and SLOPE For Stereo or Mono signals, use both L/R inputs